Photoelectric Label Sensor, NPN/PNP, Slot Type

0 reviews • Write a review

from

$189.76

Ex Tax: $189.76

Stock: In Stock
Model: RDDLZ-PHOS-TR03
Weight: 1.00
SKU: RDDLZ-PHOS-TR03

Available Options

Short Description

Output Mode

Connection

Qty

Add to Cart

Buy Now Question?

Add to Wish List Compare this Product

Shipping & Returns

Create unlimited custom product blocks and display them in accordions or tabs or open blocks. Each block can be assigned to all products at once or specific products according to advanced criteria.

Additional Product Info

Create unlimited custom product blocks and display them in accordions or tabs or open blocks. Each block can be assigned to all products at once or specific products according to advanced criteria.

The photoelectric label sensor supports 12-24VDC wide range power input, has an operating temperature range of -20~60℃ and IP65 protection level, and is widely used in automated packaging and printing equipment such as label positioning and transparent label detection.

Specification

Model	NPN	RDDLZ-LAP-TR03TNB	RDDLZ-LAP-TR03TNB-F3
	PNP	RDDLZ-LAP-TR03TPB	RDDLZ-LAP-TR03TPB-F3
Connection		2m 3 pins cable	25cm cable + M8 connector
Slot width		3mm
Slot depth		60mm
Label minimum spacing		≥2mm
Light source		Infrared light (940nm)
Response frequency		Max 10kHz
Label passing speed		≤20m/min (0.3m/s)
Response time		≤50μs
Delay after startup		≤300ms
Supply voltage high/low		12-24VDC (Ripple≤15%)
Current consumption		≤30mA
Warning output		Red indicator light on
Switch output function		Light on/ dark on (Switchable)
Voltage drop		≤2V
Output current		≤10mA
Indicator		Red light: Calibration error/operation error; Green light: NO NC; Blue light: detect label switch output signal
Operation temperature		-20-60℃ (No icing, no condensation)
Storage te mperature		-30-70℃
Protection degree		IP65
VDE safety level		Ⅲ
Weight		Approximately 55g (100g with wire)
Material		Zinc die casting; surface electroless nickel plating (Silver); PC plastic

Dimension (Unit: mm)

Wiring diagram

Tips: Precautions for using photoelectric label sensor

Make sure the power supply voltage is within the rated range before powering on.
The sensor can detect normally after 100ms of power on.
When the sensor and the load use different power supplies, please make sure to turn on the power of the sensor first.
When the sensor is not in use, it is recommended to cut off the power on the load first, and then cut off the power on the sensor.
Do not subject the sensor to severe external force (such as hammering, etc.) during installation to avoid damaging the sensor performance.
Avoid using thinners, alcohol or other organic solvents when cleaning.

Builder in Product TAB

NEW! Since Journal 3.2, the much improved T.A.B (Tabs Accordion Blocks) system supports the page builder inside the tab content. Unlimited Blocks, Tabs or Accordions with any HTML content or the builder interface (supporting custom rows/columns/modules) can be assigned to any individual product or to certain groups of products, like entire categories, brands, products with specific options, attributes, price range, etc. You can indicate any criteria via the advanced product assignment mechanism and only those products matching your criteria will display the modules. Also, any module can be selectively activated per device (desktop/tablet/phone), customer login status and other criteria. Imagine the possibilities.